Products

Jims crank pin is made of 8620 steel with .062 heat treated penetration. Crank pin is 3 oil hole type. FITMENT 1957 / 1981 XL Early 1981ACCESSORY ...

Jims crank pin is made of 8620 steel with .062 heat treated penetration. Crank pin is 3 oil hole type. FITMENT 1981 / UP XL Late 1981ACCESSORY ITE...

Jims 35mm hex fork nut socket tool removes or installs the top fork nut and has a 3/8 drive. Tool has a rubber protector on the inside to prevent ...

Jims 4th gear countershaft for 5-speed stock ratio FITMENT 1979 / 1993 FLT 1979 / 1993 FLT 1982 / 1993 FXR 1982 / 1993 FXR 1986 / 1993 FXST ...

Our Big Twin alternator rotor puller uses the sprocket shaft end to center the two threaded holes in the rotor to allow its safe removal. *NOTE: Fo...

Used to hold the hydraulic tensioners in place when repairing Beta engines. Hydraulic tensioners are used to keep constant chain tension on the cou...

Jims brake caliper piston remover tool will support the brake caliper pistons for removal holding the pistons square to their bores. This tool pre...

Jims breather ream tool repairs damaged breather gear holes. Using this tool will repair damaged breather hole to use a .030 oversize breather gea...

Jims bushing remover/installer tool will help remove and install bushings in cam support plate on TC-88 models. FITMENT 1999 / 2017 FXST 1999 / 2...

Jims cam bearing and bushing alignment tool checks the alignment of cam bearing to cam cover bushing. Any binding of this tool indicates misalignme...

Jims cam bearing installer tool presses the inner cam bearings smoothly into the right case with the bearings installed to the proper depth. FITME...

The Jims cam bearing puller tool is used to remove the bearing from the crankshaft and is designed to do this with no slipping or binding. FITMENT...

Jims cam cover bushing remover tool will remove the cam cover bushing and will also remove cam bushing in case. This tool is sturdy reliable and i...

This alignment tool is designed to index the cam gears position while removing on installing the cam gear. You will be able to accurately position ...

The cam gear remover tool is used to remove the cam gear from the camshaft. The tool acts as a stable base to keep the camshaft perpendicular to th...

Jims cam locking wedge tool will lock the gear teeth on the TC-88 model engine. Instructions included. FITMENT 1999 / 2017 FXST 1999 / 2017 FLST ...

Jims cam shaft remover and installer tool allows removal and installation of cams in the TC-88 model engine. Tool is used in conjunction with cam c...

Using the special Jims precision insert this tool is designed to easily and accurately convert the left side crank roller bearing to the more dura...

Tool is needed to spot face the right case so that the bolt head will seat flat on the case surface. This tool is required when any Twin Cam case s...

Jims castle nut socket is for use with FXST inverted forks. 2017-up Softail models requires the castle nut to secure and compress the fork spring. ...

Required when any Twin Cam case cylinder spigot hole is enlarged for Big Bore cylinders. FITMENT 1999 / 2017 FXST 1999 / 2017 FLST 1999 / 2016 F...