bigtwin prodgroup Tools

The wheel chock features quick mounting and removal by sliding in and out of slotted mount pads and secures a motorcycle on your wood floor trailer...

This Jims spigot bore tool allows the boring of cylinder spigot hole up to 3.8125 by using the stock cylinder base holes. FITMENT 1984 / 1998 FXS...

Cam bearing remover tool allows the removal of needle bearings while keeping the needles from falling into the engine. For use with bearing as lis...

This four piece tool safely installs the inner cam bearings to the proper depth in the case without damaging bearings. Complete 8 piece tool by V T...

This Jims shaft turning tool fits spline or taper on assembled motor and allows engine to be turned over by 1/2 ratchet or impact driver. FITMENT...

Using the special Jims precision insert this tool is designed to easily and accurately convert the left side crank roller bearing to the more dura...

This tool removes the starter ring gear rivets from clutch shells. FITMENT 1990 / 2006 FXST 1990 / 2006 FLST 1990 / 2006 FLT 1991 / 2005 FXD A...

This excellent tool upgrades Jims bearing installer tool for work on fine splined Twin Cam sprocket shafts. Allows for installation of Timken beari...

This tool allows for perfect installation of the main drive gear oil seal on the assembled transmission to its proper depth. The protective sleeve ...

The Jims primary locking tool is used to lock the clutch hub sprocket to the front engine sprocket. It also allows the removal or torquing of clutc...

The Jims torque plate is lasered with correct torquing sequence and will also work on Eagle big bore cylinders. FITMENT 1999 / 2017 FXST 1999 / 2...

The cam gear remover tool is used to remove the cam gear from the camshaft. The tool acts as a stable base to keep the camshaft perpendicular to th...

This alignment tool is designed to index the cam gears position while removing on installing the cam gear. You will be able to accurately position ...

The Jims cam bearing puller tool is used to remove the bearing from the crankshaft and is designed to do this with no slipping or binding. FITMENT...

The Jims inner cam bearing remover replaces the inner bearing easily without damage to crankcases and also prevents rollers from falling into the c...

Jims wrist pin remover tool will cut the time it takes to remove and install wrist pins. This remover tool can be easily used by one person. *NOTE:...

This crankshaft bearing tool is designed to remove and repla ce the right crankcase bearing in and out with no damage to crankcase. FITMENT 1999 /...

The Beta engine stand is powder coated steel and clears the rear balancer housing of the Beta style TC case. FITMENT 1999 / 2017 FXST 1999 / 2017...

This Sifton cam bearing puller tool removes the inner cam bearing Torrington type without splitting cases while preventing rollers from coming out...