bigtwin prodgroup Tools

Jims camshaft needle bearing remover and installer tool is required for correct and accurate replacement of the camshaft inner needle bearing for M...

Jims left main bearing oil seal installer assists with perfect installation and adds the advantage of allowing the alternator stator to remain in p...

Jims main bearing remover and installer tool removes the left and right main bearing without damaging the case it also provides correct alignment ...

This valve is used with Jims compression release valve tool. Release valve will make starting your engine effortless. Set of two. Drill and tap eac...

Use this tool for machining all Twin Cam heads for compression releases. Installs easily on front or rear head with or without valves installed. O...

The Jims piston support plate provides a non-marring flat support to push the bottom of the piston as rings and cylinder are installed over piston....

Number stamp tool holds the letter or number stamps from the motor number stamp sets. FITMENT 0 / Custom applicationTECH NOTESSuggested to use w...

Jims rolling buddy engine dummy plate is to be used on all rubber mount Big Twins. This tool will allow chassis to be moved once the engine has bee...

DIY Touring tool kit for 2017 FLT models. Kit includes rider tools and service tools for the rider-mechanic. This DIY tool kit will help the rider ...

Jims castle nut socket is for use with FXST inverted forks. 2017-up Softail models requires the castle nut to secure and compress the fork spring. ...

Tool is used for installation and removal of the pinion gear. Can be used to install gear on 1951-1953 Big Twin 61 and 74 overhead valve.FITMENT ...

To remove and replace wrist pin bushing without removing connecting rods from crankcase use the Jims TC-88 connector rod bushing tool. FITMENT 19...

Fork cap nut socket wrench tool for use an 41mm fork plugs. Thin design allows for removal of fork plug without disassembling handlebars. Will remo...

Jims tappet position holding tool for Twin Cam and Sportster engines. This tool allows the tappets and anti-rotation pins to be safely and accurate...

Jims clutch adjusting tool for use on Big Twins 1985-up allows the mechanic to quickly and accurately tighten the clutch adjusting screw jam nut wi...

Jims transmission assembly vise stand tool is used to assist in the assembly of the transmission gears and shafts. This tool holds the shafts in pe...

Jims main drive gear case seal installer tool ensures correct alignment and installs seal to the correct depth without damaging seal. FITMENT 1985...

This tool safely removes and installs the inner primary bearing without damage to the new bearing. Also removes and installs inner primary and seal...

Jims extended fork tube compressor tool is to be used with fork spring for compressor tool which puts pressure on top fork plug to compress the spr...

Pushrod cover removal and installation tool fits TC-88 models. FITMENT 1999 / 2017 FXST 1999 / 2017 FLST 1999 / 2017 FXD 1999 / UP FLT ACCESSO...