category Chassis

Rear frame swingarm features a chrome finish. Bearings and races are not included. FITMENT 1970 / 1984 FX ACCESSORY ITEMS44-197344-010144-1995

Chrome engine bar features 1-1/4 tubing with an integral footpeg area for M8 models. WARNING: This engine/frame bar may provide limited leg and co...

Frame top engine mount is two halves with seat tee and rear tank mounts incorporated into the top mount. Weld in place for accurate restoration. *N...

Raw steel 45 W rear fender brace set includes chain guard mount tab and stock mount tabs that are used to bolt to frame. The straps measure 7/8 wi...

Raw steel hardtail rear frame section has replica forged axle plates for the exact look of the 1950's rigid frames. Accepts FXST oil tank transmis...

Chrome finish dropped swingarm features a raised up axle position so this lowers the swingarm and chassis in relation to the axle. Axle slots are ...

Oil tank bracket kit adds accurately formed stamping for use for restoration of original tanks. This is a 3 piece kit. *NOTE: Must be welded on.FIT...

This raw steel full rear section hardtail for Sportsters includes the rear motor mount and 4 bolt plate mount with upper and lower tube set. Frame ...

Lower frame brace tube is for under the main tank tube. 1 diameter must be welded in place.FITMENT 1938 / 1952 EL 1948 / 1957 FL ACCESSORY ITEMS...

Rigid frame rear engine mount and front transmission mount with forging mark. FITMENT 1936 / 1940 EL 1941 / 1957 FL 1938 / 1947 UL ACCESSORY IT...

Lower frame tube brace set is for use on right and left rigid and straight wishbone frames. Set includes the right and left side with chain offset...

Fender cross brace kit for Knucklehead frames. Kit includes two saddles that must be brazed in place.FITMENT 1936 / 1947 EL 1941 / 1947 FL ACCESS...

Raw fender cross brace is for use on Panhead rigid frames. Tube measures 1 outer diameter and needs to be welded in place. Kit does not include sa...

Rigid rear fender cross tube for use on Knucklehead frames features a raw finish. Rigid frame cross tube is for rear fender mounting. Must be cut t...

Seat post rigid frame tube is constructed of steel and features a raw finish. Bushings not inclulded. Must be cut to final length and welded in pla...

Rigid Big Twin lower frame tank mount set needs to be welded on for restoration or repair. Mounts are constructed of steel and have a raw finish. M...

Raw set of right and left axle plates for Sportster hardtails features 7/8 slots on both sides. FITMENT 1982 / UP XL ACCESSORY ITEMS51-038751-0...

45 front engine clutch cable mount features a raw finish and must be welded to the center tube. FITMENT 1941 / 1952 W 1941 / 1973 G ACCESSORY I...

Front engine mount weld on frame brace for 45 solo frames. *NOTE: Frame parts are forged and machined using tooling exclusively by V-Twin MFG.FITME...