classic subprodgrp Fenders

Dresser type rear fender is 9 wide and features a bobbed style end. Fender is undrilled and constructed of steel with a raw finish. May require so...

Untrimmed ribbed fender with a raw finish and is 5 wide and 1mm thick. Ends unfinished. Position cut drill mount holes as required. *NOTE: Fender ...

Rigid rear fender tail with hinge does not have the tail lamp cutout. FITMENT 1949 / 1957 FL MEASURMENTSWidth: 7-13/16 inchesACCESSORY ITEMS28-22...

Zinc plated steel bracket used to adapt one piece FXDF front fenders to fit FLH forks on 1949-up 41mm models. Set of two. Bracket is formed from la...

Replica front fender has a raw finish with indent. Includes brackets riveted on. Before priming or painting fit the fender body braces and mounti...

Replica fender rear is constructed of steel and has a primer finish. Fender has early tail lamp cutout and accepts stock tail lamp. We suggest pre ...

Replica glide front fender is constructed of steel and has a raw finish. Order hardware separately. We suggest pre fitting the fender prior to pain...

Smooth style rear fender tail end with hinge features a seamed construction to accept stainless steel fender trim. For use on rigid frames. Must ...

Rear rigid fender hinge assembly features a raw finish and includes a 2 piece hinge plate and pin. Must be riveted in place. Hinge holes measure 5....

Bobbed rear fender has a raw finish with left cutout. Fender is 7-1/4 wide by 5-1/2 deep and is for rigid models. Includes bracket to accept tail...

Rigid rear bob fender brace is constructed of raw steel. Brace features 3/4 wide strap and mount tabs that are riveted in place. The left side fea...

Replica rear fender with hinged tail and tail lamp cutout. Accepts late 1973-up large style tail lamp. Fender has turn signal bar indent and holes....

Bobbed rear fender with side skirt panels is for rigid models includes brackets and is 7-3/8 wide. The fender end is trimmed smooth. The inside w...

Dresser type rear fender is 8 wide and features a bobbed style end. Fender is undrilled and constructed of steel. May require some modification. W...

Bobbed rear fender kit includes a pre drilled steel fender chrome sturts chrome tail lamp bracket and stock style tail lamp. We suggest pre fitt...

Spring fork front fender has a raw finish and is 7-1/2 wide for 16 or 18 wheels. Fender is equipped with two top holes and four rivet holes. Fen...

Replica rear fender has a raw finish and is one piece.Fender is equipped with turn signal indents. Fender uses late 1973-up large style tail lamp. ...

Short flat front fender has a raw finish and is constructed of steel. For use on 16 wheels and is without brackets. We suggest pre fitting the fen...

One piece stamped spring fork front fender without holes and a raw finish. The side panels are pressed into fender body. Braces are not included. F...

Replica rear fender is flip style with hinged tail. Fender uses late 1973-up large style tail lamp and must be cut out. This fender is not equipped...

Bobbed rear fender kit includes steel fender chrome struts chrome tail lamp bracket and cateye tail lamp. We suggest pre fitting the fender prio...

Replica raw Spring Fork front fender features a two piece construction with wide braces riveted into the fender body. Fender braces fit on the outs...

Spring Fork front fender with raw finish OE style rivets a one piece seamless fender body and narrow braces Fender braces fit on the outside of ...

Replica smooth rear fender is one piece and has three drilled holes for struts. Uses Tombstone or Beehive tail lamp. Fender is equipped with clips ...