classic subprodgrp Fenders

Bobbed rear fender has a raw finish with left cutout. Fender is 7-1/4 wide by 5-1/2 deep and is for rigid models. Includes bracket to accept tail...

Replica front fender has a raw finish without fender lamp holes. Features two piece spot welded skirt panels and narrow width braces. Fender braces...

Rigid rear bob fender brace is constructed of raw steel. Brace features 3/4 wide strap and mount tabs that are riveted in place. The left side fea...

Replica rear fender with hinged tail and tail lamp cutout. Accepts late 1973-up large style tail lamp. Fender has turn signal bar indent and holes....

Bobbed rear fender with side skirt panels is for rigid models includes brackets and is 7-3/8 wide. The fender end is trimmed smooth. The inside w...

Dresser type rear fender is 8 wide and features a bobbed style end. Fender is undrilled and constructed of steel. May require some modification. W...

Bobbed rear fender kit includes a pre drilled steel fender chrome sturts chrome tail lamp bracket and stock style tail lamp. We suggest pre fitt...

Spring fork front fender has a raw finish and is 7-1/2 wide for 16 or 18 wheels. Fender is equipped with two top holes and four rivet holes. Fen...

Replica rear fender has a raw finish and is one piece.Fender is equipped with turn signal indents. Fender uses late 1973-up large style tail lamp. ...

Short flat front fender has a raw finish and is constructed of steel. For use on 16 wheels and is without brackets. We suggest pre fitting the fen...

One piece stamped spring fork front fender without holes and a raw finish. The side panels are pressed into fender body. Braces are not included. F...

Replica rear fender is flip style with hinged tail. Fender uses late 1973-up large style tail lamp and must be cut out. This fender is not equipped...

Bobbed rear fender kit includes steel fender chrome struts chrome tail lamp bracket and cateye tail lamp. We suggest pre fitting the fender prio...

Replica raw Spring Fork front fender features a two piece construction with wide braces riveted into the fender body. Fender braces fit on the outs...

Spring Fork front fender with raw finish OE style rivets a one piece seamless fender body and narrow braces Fender braces fit on the outside of ...

Replica rigid rear fender has 1949-1950 style chain relief cutout. Fender is fully assembled and riveted together with hinge. Before finishing with...

Replica smooth rear fender is one piece and has three drilled holes for struts. Uses Tombstone or Beehive tail lamp. Fender is equipped with clips ...

Replica glide front fender with a raw finish with correct early type bracket set riveted on. Fender is without trim holes. Before priming or painti...

Raw front fender is a glide style fender with wide Spring Fork braces to fit servi-cars with an offset rocker Spring Fork and a star hub wheel. Axl...

Replica rear fender accepts tail lamp. Uses either stock or smooth struts. We suggest pre fitting the fender prior to painting. Before priming or p...

Rear fender end with one half of hinge riveted on the one end. This fender end is not equipped with tail lamp hole or pre drilled. We suggest pre f...

Round profile chopper fender is a round British style without rib. Note: All fenders are shipped raw. Fenders have tooling marks on the rolled or b...

Rear fender end with hinge features a raw finish. The brace measures 5/8 wide. Set includes stay bars. We suggest pre fitting the fender prior to ...

Wyatt front fender is 2mm thick raw steel laser cut from full piece blanks. The outer diameter of the bracket is 8 . Inside width of the fender is ...