prodgroup Tools

Jims left main bearing oil seal installer assists with perfect installation and adds the advantage of allowing the alternator stator to remain in p...

Jims main bearing remover and installer tool removes the left and right main bearing without damaging the case it also provides correct alignment ...

Jims balancer scissor gear alignment screw tool holds the two halves of the spring loaded scissor balancer gear in alignment before removal for eas...

This valve is used with Jims compression release valve tool. Release valve will make starting your engine effortless. Set of two. Drill and tap eac...

Use this tool for machining all Twin Cam heads for compression releases. Installs easily on front or rear head with or without valves installed. O...

The Jims piston support plate provides a non-marring flat support to push the bottom of the piston as rings and cylinder are installed over piston....

Use the balancer shaft retention pin tool secures the engine balancers on TC-88B engines when servicing flywheel assembl y. This tool locks into th...

Number stamp tool holds the letter or number stamps from the motor number stamp sets. FITMENT 0 / Custom applicationTECH NOTESSuggested to use w...

Jims rolling buddy engine dummy plate is to be used on all rubber mount Big Twins. This tool will allow chassis to be moved once the engine has bee...

DIY Touring tool kit for 2017 FLT models. Kit includes rider tools and service tools for the rider-mechanic. This DIY tool kit will help the rider ...

Rod alignment plate features a cast iron construction with a parkerized finish for Big Twin engines. FITMENT 1936 / 1952 EL 1941 / 1985 FL ACCE...

Jims castle nut socket is for use with FXST inverted forks. 2017-up Softail models requires the castle nut to secure and compress the fork spring. ...

Tool is used for installation and removal of the pinion gear. Can be used to install gear on 1951-1953 Big Twin 61 and 74 overhead valve.FITMENT ...

Our crankshaft locking tool fits 1991-1999 XL models by engaging the pinion shaft splines. This allows removal and torquing of the pinion nut durin...

Tool pushes against the top rocker box to allow one hand operation and is for use on 1936-1998 Big Twin and 1957-2003 XL models. FITMENT 1936 / 19...

To remove and replace wrist pin bushing without removing connecting rods from crankcase use the Jims TC-88 connector rod bushing tool. FITMENT 19...

Sifton cam cover bushing remover tool will remove the cam cover bushing and will also remove cam bushing in case. This tool is sturdy reliable and...

Clutch hub nut wrench kit includes a factory style wrench and nut with a Sifton patch. FITMENT 1936 / 1940 EL 1936 / 1940 EL ACCESSORY ITEMS49-0...

Includes three interchangeable adaptors to service all carburetors to remove venturis. The 1-3/16 collar is used for M-4 ll 16 and 18 carbureto...

Fork cap nut socket wrench tool for use an 41mm fork plugs. Thin design allows for removal of fork plug without disassembling handlebars. Will remo...

Jims tappet position holding tool for Twin Cam and Sportster engines. This tool allows the tappets and anti-rotation pins to be safely and accurate...

Oil pump reseat tool will facilitate ball burnishing of the relief valve seat on cast iron pumps. FITMENT 1941 / 1968 FL 1936 / 1952 W 1936 / 19...

Jims clutch adjusting tool for use on Big Twins 1985-up allows the mechanic to quickly and accurately tighten the clutch adjusting screw jam nut wi...